YG1 83593TF 1/2″ Size, 5/8″ LOC, 3 Flute, YG TiAlN Futura Solid Carbide Finishing End Mill Sale

Applications

Designed for finishing tasks requiring high rigidity and precision, the YG1 83593TF solid carbide end mill features a 1/2″ diameter and a 5/8″ length of cut, yielding a stub length ratio of 1.25x. Its 3-flute architecture, paired with a 50° helix angle and TiAlN Futura coating, fosters a low-friction cutting environment that effectively reduces built-up edge and enhances surface finish on steels, stainless steels, cast irons, and heat-resistant superalloys. This combination ensures efficient chip evacuation and sharp cutting edges for consistent, smooth finishes. It is important to note that this end mill is not recommended for non-ferrous materials, as the coating unsuitability may cause rapid wear and shorten tool life. The lack of a corner radius optimizes it for clean, sharp cuts rather than interrupted or roughing operations where chipping resistance is important. The center-cutting design enables plunge cutting and slotting within the specified materials. The synergy of the high helix angle and TiAlN Futura coating aligns with ideal finishing practices that demand fine surface quality and dimensional accuracy in steels and related alloys. This tool is best reserved for finishing passes and is unsuitable for heavy roughing or machining non-ferrous metals.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The high rake angle and 50 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.