Secure Checkout YG1 55565TE 3/16″ Size, 1-1/8″ LOC, 4 Flute, YG TiAlN Extreme Solid Carbide Finishing End Mill

Applications

Offering a 3/16″ diameter with a 1-1/8″ length of cut, the YG1 55565TE solid carbide end mill achieves a 6.0x length of cut-to-diameter ratio that provides both reach and rigidity for precise milling in confined or deep areas. Its 4-flute configuration, combined with a 30° helix angle and YG TiAlN Extreme coating, delivers robust chip evacuation and edge strength, making it suitable for general milling of free-machining steel and similar materials. This coating excels in heat resistance and wear performance, aligning with best practices for low carbon steel slotting and milling. Recommended primarily for steel (ISO P), this tool also suits cast iron (ISO K), stainless steel (ISO M), and heat-resistant superalloys (ISO S). However, it is not appropriate for non-ferrous materials (ISO N) due to coating limitations that cause rapid wear. The absence of a corner radius necessitates vigilance against edge chipping during interrupted cuts. This center-cutting end mill also enables plunge cutting, enhancing its utility within the specified material range, and follows best combination guidelines for free-machining steel in various milling operations.

Features

• Suitable for cutting hardened & high alloy steels, steel casting, chill casting, malleable cast iron, CrNi-steels, brass, copper, aluminum with a high percentage of silicon and abrasive plastics.